- Description
ULTRA GLOSS MARINE TOPSIDE POLYURETHANE ENAMEL
FOR BRUSHING, ROLLING & SPRAY APPLICATION
20 YEAR WARRANTY
Each gallon of Ultra Gloss marine polyurethane paint covers approximately 400 square feet per gallon; 2 coats needed for proper application.
Ultra Gloss is technically an advanced single component topside polyurethane enamel paint giving your boat a hard protective coating for super high gloss, color retention, and long durability. Ultra Gloss is fast drying which when brushed or rolled gives a smooth finish with excellent handle and flow. This widely used topside marine polyurethane enamel has tremendous resistance to tough chemicals, cleaning solutions and ultraviolet light with its advanced ultraviolet technology. This marine polyurethane can be used on wood, fiberglass, aluminum and steel.
SUGGESTED USES: Topside, decks, cabin, masts, bilge, waterline, boottop striping, industrial and offshore structures.
LIMITATIONS: Do not apply if material, substrate or ambient temperature is below 50 degrees F or above 95 degrees F.
FINISH: Gloss
VEHICLE TYPE: Polyurethane alkyd resin.
SOLVENT TYPE: High flash naphtha.
VOC: 3.76 lbs./ gal. (450 grams/liter).
SOLIDS BY WEIGHT: 50%.
RECOMMENDED DRY FILM: 4.0 mils.
WEIGHT PER GALLON: 10 Lbs. per gallon (varies by color).
VISCOSITY AT 75 DEGREES F (24 DEGREES C): 70-80 KU
AVERAGE DRY TIME AT 75 DEGREES F: Dries to touch in 4 hours. Lower temperatures & higher humidity will slow down dry times.
RECOMMENDED REDUCER: Xylene for spray application, high flash naphtha for brushing or rolling.
RESISTANCE TO: Chemicals resistance, abrasion, oils, grease, rust, corrosion, mildew, chipping and fading.
COVERAGE: Approximate coverage at two mils dry is 300-400 square feet per gallon, and recommended thickness of 4 mils dry would require 2 full coats. Material losses during mixing and application will vary and must be taken into consideration. Expect less coverage on bare, rough or sandblasted surfaces.
APPLICATION: Brush, spray or roller. Roll: 1/2" nap mohair metal, lambskin, phenolic core roller. Keep roller wet. Roll in one direction, rewet, then cross roll. Spray: Conventional air gravity feed 59-70 PSI, Tip size .055-.070, Airless 2200-2500 PSI, Tip size .013-.017. Product can be reduced with xylene as needed for proper flow out and performance. For air spray reduce 25% with enamel reducer (xylene).
POT LIFE: Not applicable.
SHELF LIFE: Maximum 12 months.
MIXING: Mechanically mix for 10 minutes, making sure that all solid material is mixed thoroughly.
CLEAN UP: Xylene for equipment.
PACKAGE: 1 Gallon can
